ColorFabb PLA Magenta
ColorFabb PLA Magenta 1.75mm 750g
Revolution 3D Printers we have extensively tested and verified ColorFabb PLA Magenta filament on our Infinity 3d printers. We know the ColorFabb PLA Magenta materials will give you excellent results and to help you get these results here are tips and trick for using ColorFabb PLA Magenta 3D printing filament.
Advised 3d printing temperature:
200c Infinity 3D
Advised 3d print speed:
40 – 100 mm/s
Advised Heated bed (if you have one, not strictly necessary):
ColorFabb PLA Magenta performs well on both heated and non-heated build platforms. For those users printing on a cold build platform we advise applying masking tape to the build area. The rough surface of the tape will provide enough adhesion for the first layer of ColorFabb PLA Magenta to stick and print almost without any warping.
Users using heated build platforms have quite a few options these days. The usual suspects are glass and aluminum build plates. For directly printing ColorFabb PLA Magenta on glass or aluminum we advice user to apply glue-stick. A very thin layer will be sufficient to keep your ColorFabb PLA Magenta print nicely in place. Another method is dissolving wood glue in water, you the consistency of the substance can be quite thin, a bit like milk. By applying just a few drops and smearing this out before you start heating the built plate will create a very thing layer which holds the ColorFabb PLA Magenta down very well. If applying this method, be careful that you don’t get your electronics wet.
Another method that works well with ColorFabb PLA Magenta is polyimide tape, or Kapton tape. This tape is available as a very narrow strip or very wide strips which allow you to cover the build plate in one go. When the tape is applied correctly it can last for months.
TIP! Take your time leveling the bed (unnecessary with the Infinity line of 3D Printers) and adjusting the the gap between 3d printer nozzle and build plate. A perfect first layer will is very important, especially for 3d prints with a large bottom layer. Having the nozzle set to close to the build plate will cause a pressure build up and as a result back flow in most hot ends.
TIP! ColorFabb PLA Magenta has very minimal warping tendencies, however if your printing parts which take up the maximum of you build space you might see some warping. If it’s very important that your part is perfectly flat than we suggest to turn down the fan that is cooling your part. This allows the ColorFabb PLA Magenta material to slowly get rid of heat without warping. After a few centimeters you can turn on the cooling if the ColorFabb PLA Magenta part needs it.
*3d printers have lots of different types of hot-end which makes it extremely difficult to give temperature advice. We feel our temperature advice holds for most 3d printers, but should be considered as a starting point for you to find the temperatures that work in you setup. Don’t be afraid to go either higher or lower then our advised temperatures if you feel your set-up needs this.
ColorFabb PLA Magenta 1.75mm 750g
ColorFabb PLA Magenta , at Revolution 3D Printers we have extensively tested and verified ColorFabb PLA Magenta filament on our Infinity 3d printers. We know the ColorFabb PLA Magenta materials will give you excellent results and to help you get these results here are tips and trick for using ColorFabb PLA Magenta 3D printing filament.
$49.95Dimensions : 23 x 21 x 7 cm