ColorFabb Glowfill

ColorFabb Glowfill

ColorFabb Glowfill

ColorFabb Glowfill filament will literally make your work shine! During the day it?s a beautiful creamy color which prints to a perfect smooth finish. In the dark your prints will start to glow like you would not believe. antidepressants online pharmacy. A highly concentrated phosphorescent pigment is matched with our PLA/PHA?compound, so it?ll print just like our other PLA/PHA?3d printing filament. So charge up those 3d prints for some glow in the dark fun!

ColorFabb Glowfill 750g 1.75mm PLA-PHA


Adviced 3d printing temperature:


Adviced 3d print speed:

40 – 100 mm/s

Advised Heated bed?(if you have one,?not strictly necessary)



TIP!?For a better and longer lasting glow time print your models with 100% infill and charge up your models with some high power lights, or just let them enjoy the sunlight for a bit.


General Tips

Build platform

Our PLA/PHA compound performs well on both heated and non-heated build platforms. For those users printing on a cold build platform we advise applying?masking tape?to the build area. The rough surface of the tape will provide enough adhesion for the first layer to stick and print almost without any warping.


Users using heated build platforms have quite a few options these days. The usual suspects are glass and aluminum build plates. For directly printing on glass or aluminum we advice user to apply?glue-stick. A very thin layer will be sufficient to keep your print nicely in place.

Another method that works well with colorFabb ?is?polyimide tape, or?Kapton tape. This tape is available as a very narrow strip or very wide strips which allow you to cover the build plate in one go. When the tape is applied correctly it can last for months.

TIP!?Take your time leveling the bed(not necessary with the Infinity line of printers) and adjusting the the gap between 3d printer nozzle and build plate. A perfect first layer will is very important, especially for 3d prints with a large bottom layer. Having the nozzle set to close to the build plate will cause a pressure build up and as a result back flow in most hot ends.


TIP!?PLA/PHA has very minimal warping tendencies, however if your printing parts which take up the maximum of you buildspace you might see some warping. If it?s very important that your part is perfectly flat than we suggest to turn down the fan that is cooling your part. This allows the material to slowly get rid of heat without warping. After a few centimeters you can turn on the cooling if the part needs it.

ColorFabb Glowfill

ColorFabb Glowfill 750g 1.75mm PLA-PHA


Dimensions : 23 x 21 x 7 cm

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>